|
#1
|
||||
|
||||
LRP Flow 5.4 firmware in gt12 and lipo cutouts
Hi all,
As the title i'm running a flow team with the 5.4 stock firmware and have noticed it pulsing or cutting on throttle on heavy acceleration as if the lipo cut-out is coming in. Its also confirmed if you hit the throttle and hold the car as it wont wheelspin it just cuts power. Is there anyway to disable the lipo low volt cutout altogether? From what i can see there is only two options, esc protection and esc and motor protection. If it means reverting to another firmware which one? Cheers Andy |
#2
|
||||
|
||||
Hi
Have you tried another sensor cable ?
__________________
~Rick Evans~ ~LRP~shark st ft~lwb~ ~Carisma GT14B pro~ ~Schumacher KF2~ ~Schumacher Atom~ ~BSR Basher-RallyX~ ~Ascociated RC8.2e RallyX~ ~TeamC T8EV3 RallyX~ phat bodies worm-racing http://www.mendiprcraceway.co.uk |
#3
|
||||
|
||||
Yes, did try another sensor cable.
|
#4
|
|||
|
|||
Flow needs a booster for 1s lipo speedo and servo draw to much power
I think it says in the instructions booster required |
#5
|
||||
|
||||
Are you running a booster or receiver pack?
__________________
~Rick Evans~ ~LRP~shark st ft~lwb~ ~Carisma GT14B pro~ ~Schumacher KF2~ ~Schumacher Atom~ ~BSR Basher-RallyX~ ~Ascociated RC8.2e RallyX~ ~TeamC T8EV3 RallyX~ phat bodies worm-racing http://www.mendiprcraceway.co.uk |
#6
|
|||
|
|||
In specification section
Be aware you will need a rx pack or a booster for 1 s lipo use |
#7
|
||||
|
||||
I've got the RC dynamics one I no longer use,I used it on my flow 👍🏼
PM me if interested |
#8
|
||||
|
||||
Yes its running a booster, there are no brownouts. The problem is lipo cut out.
|
#9
|
||||
|
||||
You need to turn off the voltage cutoff with the booster,
If you go on the LRP site it tells you what firmware is best suited Last edited by reg; 13-06-2015 at 08:11 PM. |
|
|