Quote:
Originally Posted by stuhurley
I broke a front wishbone yesterday and replaced it with a B44 one. There's a small amount of dremmeling to do where the inner hinge pin is (too much plastic on the B44 one) and the hinge pin hole is too small (drilled out to about 3mm).
Also broke a rear hub and replaced it in similar fashion.
I'm fitting alloy rear hubs next but have to get the hinge pin hole drilled out again (3mm).
|
So is it only the B44 part that needs changing, or did you have to dremel/drill any of the Aero?
I reckon if I can use B44 wishbones and then find some front uprights too (not the ali castor blocks) that'll fit I can risk using the car!