|
|
#1
|
|||
|
|||
KC => L1 rear conversion
Hi i'm looking for L1 rear conversion set for Schumacher KC Regards
|
#2
|
||||
|
||||
You can get the parts to convert
U7613 CVD LD Driveshaft U7493 Hex 7.5 L1 U7333 Wishbones U7368 Outboard Pivit Pin L1 U7392 Rear Hub L1 U2698 Hub Bearing
__________________
Schumacher Speed Passion Futaba Support from: My Back Pocket Driver - 'Derek' Feedback Link : http://www.oople.com/forums/showthread.php?t=48311 |
#3
|
||||
|
||||
rear hub bearings are the same between kc and ld
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#4
|
||||
|
||||
Cheers Mark,
To be honest I stole the list from another thread Not owning the conversion myself ( I missed out before they became discontinued ) I was going to get the bits, now know don’t need the bearings 🤪
__________________
Schumacher Speed Passion Futaba Support from: My Back Pocket Driver - 'Derek' Feedback Link : http://www.oople.com/forums/showthread.php?t=48311 Last edited by knighthawk; 20-06-2019 at 05:36 AM. |
#5
|
|||
|
|||
the list depends on the age of the KC.
I had a kit from early this year and it had the L1 hubs and L1 length driveshafts, 67.13mm if I remember correctly. if you run a roll bar you will need the L1 joints for the lower link to wishbone as it moves from outside the arm to inside the arm. I did not change my hexes as the original kit did not have them in it, you do need an oring as a shaock bump stop though original kit had driveshafts hubs arms orings c clips spacers |
#6
|
||||
|
||||
The conversion kit had Cat SX rear driveshafts in it, you can use the lay down driveshafts but you would need to get the L1 1.5mm hexes.
__________________
TLR, Screwz4RC, Spektrum, Horizon Hobby, Trinity, Trishbits, Racer, RichPaint, RDT products, Sanwa, Zen Racing, Silverback Lipo's http://www.screwz4rc.co.uk My Trader Feedback - http://www.oople.com/forums/showthre...hlight=tyreman
|
|
|