|
#1
|
|||
|
|||
B4 - Servo Saver - Glueing Mod Problem
Hi Everyone,
Whenever I glue the servo saver in my B4, the ball end thread which screws into the servo horn eventually breaks out, resulting in a broken servo horn. I change the servo horn for a new one, only for it to happen again. Nothing else on the steering breaks, just the servo horn itself where the thread for the ball end screws in. Are there any ideas around this other than avoiding accidents? Thanks everyone |
#2
|
|||
|
|||
maybe get a aluminum servo horn
|
#3
|
|||
|
|||
Is there an aluminium servo horn available for the B4?
|
#4
|
||||
|
||||
The aluminum servo horn would be for the servo, not the B4. DMS, Apex and most decent model shops should stock aluminum servo horns for the main servo manufacturers.
Edit, here you go, have a little look here. http://www.apexmodels.com/gbu0-catsh...ervoHorns.html |
#5
|
||||
|
||||
i used to glue mine but got told off by loads of pepole for doing it since then (not gluing) i ve never had one snap on me
__________________
|
|
|