|
#1
|
||||
|
||||
BK2 axle measurement
Does anyone have a BK2 knocking around that someone could check a measurement on for me please? I need to know a measurement on the rear axle - specifically the distance of the centre of the roll pin hole to the face where the inside bearing rests up against. Hope someone can help!!! Cheers, Mark.
|
#2
|
||||
|
||||
BK2-are we talking of X6sqd optional longer axles??-If so the measurement is approx 17.5mm (without the spacer).....
__________________
X-Factory X-6 Cubed |
#3
|
||||
|
||||
Yep, I bought some Xfactory axles for a BK2 restoration project, but when the axles are assembled as per the manual the roll pin hole is partially obstructed by the alloy spacer that the wheel rests against. I have a feeling the Xfactory axles aren't quite long enough, hence wanting to know the exact measurement so if I can see if it is the part that is not right or something else. Cheers, Mark.
|
#4
|
|||
|
|||
Just measured one which I think came from a BK1 and I think they are the same.
|
#5
|
|||
|
|||
Sorry. Pressed the wrong button. As I was saying I have just measured one at 15.7mm ( plus or minus 0.1mm) . It probably came off a BK1 but I think they are the same as the BK2.
John. |
#6
|
|||
|
|||
Quote:
X-Factory XF5661 axles are fractionally shorter than the BK2 axles, which were used in the X6's. When the BK2 axles were used they did a great job when run with lots of drrop on an X6, but were just a fraction too long, which meant that at full plunge the driveshaft could hit the diff nut still, hence when X-Factory had MIP make axles for them, they made them the correct length needed for the X6 (which is close to but a fraction shorter)
__________________
ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
#7
|
||||
|
||||
Brilliant, thanks gents, problem solved.
|
|
|