FOR SALE shelf queen alloys sale

[HKS_TRD]

If only I was in the UK :-(

[rylance1878]

Hi Brian ,just a little enquiry on the wheels ,has the order gone in and when we looking at them being ready thanks
Al

[brian s]

alan what colour did you want,would blue or gold be ok ??
wayne has joined the forum but for some reason he cant post yet, he tried to reply to the posts on monday .
it will take 20 days to have the wheels sets made,annodised and then have the top face skimmed etc.
have let him have the list hopefully they will be ordered tomorrow

[Peakey]

Brian pm me his details and I'll get his account activated

[brian s]

Originally Posted by HKS_TRD

If only I was in the UK :-(

it would`nt be a problem to ship some to australia if you wanted to pay the post

[rylance1878]

Hi Brian ,blue or gold is great for me if he makes enough could have set of both thanks

[brian s]

extra sets have been ordered than required

[rylance1878]

Excellent defo have gold then when you know what extra sets there are I will pick which colours thanks ,looking forward to see them it make me get cracking on my optima mid restoration

[HKS_TRD]

Originally Posted by brian s

it would`nt be a problem to ship some to australia if you wanted to pay the post

How much would postage be, I was after a set in blue to suit the Kyosho hex fitting

[brian s]

i will ask at the local post office about cost of shipping to australia .
where in aus are you

[OptimaFan]

How much would shipping be to the Netherlands?

[HKS_TRD]

Originally Posted by brian s

i will ask at the local post office about cost of shipping to australia .
where in aus are you

I'm in Adelaide, South Australia

[Welshy40]

Brian,

Ok now youve got me tempted but not for wheels. Can he do knuckle arms for my Lazer as i need a redesign?

[brian s]

hi james, if you have an original that can be used as a pattern then probably yes

[Welshy40]

Originally Posted by brian s

hi james, if you have an original that can be used as a pattern then probably yes

Yes ive got a pair of original cast zx ones, however i need the two inner kin pin holes countersunk so i can put a screw from within the knuckle so a nyloc nut can hold it in place at the top and bottom. Getting fed up with losing kin pins and castor block bearings. I can send you a pair after Christmas so pm me your address. Thanks.

[brian s]

james can you p`m me a photo of the knuckle arms so i can show wayne

[Welshy40]

Not a problem, will do tonight.

[Welshy40]

Brian,

Couldn't PM you this so had to do via this thread. Hope this helps, otherwise ive got a used pair that I can send your way. Arrows point to the inner end thread within the hub, they are what I need counter sunk, only two holes but have gone a little ott with the arrows. This way with the countersunk holes I can avoid the drive shaft hitting the screw head.

[brian s]

james, so you want knuckles made with the kingpin holes csk in the bore ?

[Welshy40]

Originally Posted by brian s

james, so you want knuckles made with the kingpin holes csk in the bore ?

Basically yes, since you and i raced together as you know cars got a lot faster and the king pins keep coming out which is doing my nut in, by doing this means i should resolve the issue. Question is is it plausible?