AERO 1

[stegger]

Spanish National Champion Alberto Garcia takes TQ in both the 4wd and 2wd classes at the first spanish national with the AERO and a cr
HERE YOU GO YOU PAIR OF KNOB JOCKIES http://www.redrc.net/

[super__dan]

TQ's 2wd with the Aero???

[Lee]

Doesn`t look much like an aero to me? Its a bit fat


Is ellesmere port in wales

[Southwell]

Team L'aero?

[stegger]

Edited above

[Garry Driffill]

That paint job looks ace, loving the black at the back of the car

[Lee]

Here is my aero all mounted and a few stickers.





Now a question where do i put the PT?



I thought on the battery straps but the lead may catch on the spur at some point, i also thought about mounting it on velcro on the inside of the shell but im not sure if it sits above the speedo it could cause interference or loose its signal??

[Kecky]

It's a bit tight for space isn't it

Could you not stick it on the battery strap, and hot glue the wire along the inside edge of the chassis, to keep the lead away from the spur gear, or cable tie the wire to the bottom edge of the aluminium spur gear mount

And you deffo need to change the white wheels to yellow to set that shell off

[bigred5765]

stand it in the gap between the Rx and the Ariel mount
double side it to the rx

[KevLee]

Lee, i have fitted mine infront of the receiver. I just had to take a small amount of the forward corners of the PT to get it in the webbing of the chassis. Not sure what receiver you have in there though, mines the little spektrum one.

[Lee]

Kecky, No space for the wire to go down the side of the motor and its not long enough to go the other way

I also want to be able to use this PT in the 2wd

Ill have a look kev and see how tight it is, i have the KO302f

[Wraggy]

Does'nt the Aero come with a Crow Bar to help you get everthing in ??

[Northy]

Get an MRT clone Mr. Made-O-Money

G

[SHY]

Originally Posted by Lee

Now a question where do i put the PT?

On the backside of the rear tower works just fine! (vertical) If the wires are too short it's very easy to open it and solder on some longer ones.

Fasten it with double-sided velcro and it's easy to move to another car.

Very nice paintjob! Car looks awesome!!!

[Nick Goodall]

Have they designed their own shocks? Car looks cool by the way - nice to see some others out there now :-)

[Lee]

Yes they have Nick, they are similar to the losi cartridge design.

[Kecky]

Lee, it's a bit hard to see the motor side of the chassis, bit will the wire fit under the motor between it's curve, and the squared off inside corner of the chassis, or will it run too close the the pinion

Must admit, i prefer the transponder as far forward as poosible, just incase of a photo finish

[Lee]

It would fit in the space left where the motor curves but its the motor mount which sits flush against the side of the chassis that stops me doing it, otherwise it would be ideal

[Northy]

Nice sticker.

Does it own toe-in yet?

G

[Lee]

oh yes 2.934587639 degrees (approximatley)