|
#1
|
|||
|
|||
Sliper Clutch Set up
I am sure this has been covered and asked a few times before, I rebuilt my slipper clutch the other day and was wondering if there are any hints or tips as to how to set it up again.
I have read conflicting advice from either tighten it up fully then loose off 1/8 turn, to tighten it up fully then take out a full turn. Or hold the rear wheels and throttle to get the front jumping up 3-4 inches from the ground. I am not sure which method to use? |
#2
|
||||
|
||||
Best way i find is to try it on the particular track your racing at before you race. Most places will let you do this. Just give it a blast and adjust accordingly. A lot of people will hold the back wheels but that will be a certain setting. It won’t be suitable for all surfaces.
__________________
TLR 22 5.0 AC Elite TLR 22x4 Elite TeamC Tm2v1 TeamC Tco2c Evo Veteran |
|
|