|
#121
|
||||
|
||||
Quote:
This is a table showing you the drill size dimensions in inches http://www.gcrossett.com/zipzaps/tech/drill_bits.htm
__________________
Email: sales@insidelineracing.co.uk www.insidelineracing.co.uk PR Racing UK Facebook Page |
#122
|
||||
|
||||
Haven't got access to my instructions at the moment so have a quick question:
With the spacers you put on the pistons above the ball cups, is it the thinner ones to the front? |
#123
|
||||
|
||||
If you mean the external spacers on the shock shaft then yes it is the thinner at the front, i actually run 2 O rings on the rear end instead of the large spacer
|
#124
|
||||
|
||||
Quote:
But If you put the longer type ballcup at the rear you don't need a spacer, maybe just use the very thin one to let the spring retainer sit correctly. Also, on the front if you choose to run the one-way you may ned another spacer and/or dremel the end of the driveshaft to stop it fouling at full suspension travel. hope that helps
__________________
Email: sales@insidelineracing.co.uk www.insidelineracing.co.uk PR Racing UK Facebook Page |
#125
|
||||
|
||||
Yeah that helps thanks, useful tip too as I need to change some ball cups and don't think spares are available yet? This gives me some options with them!
|
#126
|
||||
|
||||
Quote:
If you do run the turnbuckle type ballstud i'd recommend cutting it down to the same length as the normal ballcup and spacer together, otherwise you will have too much droop.
__________________
Email: sales@insidelineracing.co.uk www.insidelineracing.co.uk PR Racing UK Facebook Page |
#127
|
||||
|
||||
Cheers Kev, last checked with them about a week ago, I'll try again!
Dave |
#128
|
|||
|
|||
servos?
what servos do u all use?
I tried to use my hitec coreless ultra speed hs-965mg its way to big. im looking for something with high speed, good torque, and if possible metal gears. thanx n advance. |
#129
|
||||
|
||||
Hi Redscott, I use the KO 2413ICS and i really get on with it, so much so i put one in my 2wd too.
Some use the Futaba short stack servo (not sure of the number) which seems pretty good also
__________________
Email: sales@insidelineracing.co.uk www.insidelineracing.co.uk PR Racing UK Facebook Page |
#130
|
||||
|
||||
The Futaba low-profile servo model number is S9551. I don't think this has been out too long so you may still be able to purchase its predecessor, the S9550, as well (although I guess the specification isn't as good for this one).
KO have got some new low profile services coming soon (the 2511 & 2512; click here), but don't appear to have released any specifications yet so I'm not sure how these compare to the 2413. HTH.
__________________
|
#131
|
||||
|
||||
Has anyone managed to set the slipper without the "slipper tool" without bending the screw?
When I tried the screw bent, I am building another tomorrow and would like to not bend the damn thing this time! |
|
|