|
#1
|
||||
|
||||
12mm hex
Would like to use schumacher wheels if possible, has anyone done this ?
Cheers . |
#2
|
||||
|
||||
check team setups from EOS. they use the 12mm adapters due to the handout wheels at EOS
__________________
Stephen Smith Answer RC Team HB Racing | Team Orion | Xpert | Racing Experience |
#3
|
||||
|
||||
There is various offsets of hexes for the xb4 so I'm pretty sure you'll find the correct one.
__________________
Team Associated Hobbywing SRT Reedy My feedback http://www.oople.com/forums/showthread.php?t=63097 |
#4
|
||||
|
||||
Cheers guys , I've seen the various hexes just not sure which ones to go for .
|
#5
|
||||
|
||||
Think you'll need to buy a few different ones and test til you get the correct offset
__________________
Team Associated Hobbywing SRT Reedy My feedback http://www.oople.com/forums/showthread.php?t=63097 |
#6
|
||||
|
||||
Sorry for being thick.... What is the offset??
|
#7
|
||||
|
||||
It all depends on the wheels you're gonna use.
__________________
Team Associated Hobbywing SRT Reedy My feedback http://www.oople.com/forums/showthread.php?t=63097 |
#8
|
||||
|
||||
I'll get the different ones and see which work , got loads of 12mm wheels be nice to make use of them .
|
#9
|
|||
|
|||
I run 22-4 offset wheels front and rear. I use +.75mm hexs on the front and +1.5mm on the rear. On the front you'll want to use a lower profile wheel nut because there's not a whole lot of thread left.
|
#10
|
||||
|
||||
Cheers , I've a load of losi 22-4 wheels so that good to know .
|
#11
|
||||
|
||||
Yes, the 22-4 low profile nut is perfect for this.
|
#12
|
||||
|
||||
Quote:
And these 7mm wide 12mm hex for the rear: http://www.exotekracing.com/xb4-12mm...ar-2-7mm-wide/ I run TLR 22-4 rims and have no complaints, no grip roll, understeer, overseer etc. The car is very nimble. |
#13
|
||||
|
||||
|
#14
|
||||
|
||||
Cheers guys .
|
#15
|
||||
|
||||
With these hexes does the car have the same width as std ?
|
#16
|
||||
|
||||
Quote:
|
|
|