nylon battery holders

[stevo16v]

ive machined up these 6 cell versions to go with the 4 cell ones
they measure 156mm the same as the wheelbase
what body shell do 6 cell racers use as i noticed there isnt much room were the body narrows ,i machined the sides narrower and thinner so they dont catch the floor under cornering ,i know loads about 4 cell racing but 6 cell isnt my field any advise

[stox217]

Need one to try, will be used in most of the saloons that run 6 cells. How much are they?

[stevo16v]

the 4 cell are £7 so i was going to do these for £7.60
i would like to make sure there what people want ,ive machined the holes to pick up the original holes
i know they will be better than the abs as they wont break and the cells will sit flat on the chassis ,the cells are really secure but am worried by the width ,they measure 156mm the same as the rear wheels and the bodies ive looked at tend to slimdown in the middle ,it pushes the fiesta shell out about 2mm each side,ur welcome to one and if u think its not for u then il refund when u post it back,
ive changed the plastic they are made of ,u carnt snap the ,ive hit one with a lump hammer and it just bounced off and it has no grain so additive will just wipe off with no black marks