|
#1
|
||||
|
||||
Lipo trouble
I tried installing my Team checkpoint lipo pack in my cat and found that the belt touches the center belt and pulley. What pack fits please?
|
#2
|
||||
|
||||
What chassis do you have and what are the dimenstions of the LIPO?
|
#3
|
||||
|
||||
I have the cat sx lipo kit #079, the battery is a team checkpoint 5000 mah. Do orion or reedy fit better?
|
#4
|
||||
|
||||
I tried three lipo's, only one fit!!!! It was the flight power dark series. Can someone tell me what else fits
|
#5
|
||||
|
||||
I'm using the Robitronic 5000, 40c's. They fit fine.
|
#6
|
||||
|
||||
does it have locating lugs on it
__________________
who knows who cares |
#7
|
||||
|
||||
I use the Nosram 5300 40C Cells, must admit when first put in the cells needed pushing down to ensure the locating lugs were correctly aligned with the holes in the chassis... But they 'bed in' after a while...
Make sure the LiPo is correctly seated.
__________________
Schumacher CAT K1 Schumacher Cougar SVII Schumacher Racing - Team Tekin - Spektrum - Inside Line Racing - TrishBits |
#8
|
||||
|
||||
I run an LRP lipo upside down so the lugs are at the top.
Works with no problem |
#9
|
||||
|
||||
Thanks for all the info, I have to say I'm a little discouraged with this lipo thing, getting the wire around to the esc wasn't a small task either. I have a degree in electo-technology (basically wireing and ic boards tech) and still had some trouble passing the wires through the belts without touching them. I hope Shumacher addressed these issues with the SX2.
Does anyone have the part number for the battery stays that hold the lipo from moving left to right. |
#10
|
||||
|
||||
Quote:
If you have a LIPO with lugs on them, look at doing a chassis change? S1 or new SX2 chassis |
|
|