|
#1
|
||||
|
||||
hi-fet servo problem.
Hi lads.
went racing yesterday, ran my pred with my hi-fet servo in there. for some reason my servo started cutting out. my esc still ran but could only get the servo going again for a few seconds once i switched off then on again. would it be the servo or rx? cheers..Alan
__________________
EAT, SLEEP & RACE. Keeping fast motors reving hard. signed...migsy racing made better by Losi, Team Xtreme, HPI BAJA 5B. novak, castle creations, trak-power lipos bantam B6 and my SMR nicely done by huski sport uk. local club: Cwmaman RC Jammers. www.the-pred.co.uk RC BEARINGS 4 U. Club 22 (admin) Losi22, losi xxx cr losi xx-4, losi xxx-4G baja 5b 30.5cc. |
#2
|
||||
|
||||
Hi-fet doesn't ring a bell.
What radio gear are you running? It sounds possible that the servo is drawing too much current, this is common with Spektrum receivers and is often solved by fitting a capacitor. |
#3
|
||||
|
||||
i'm using a ko2123 fet servo, i've had the servo for about 3 seasons from new with no trouble. my rx is cyrass 40meg.
__________________
EAT, SLEEP & RACE. Keeping fast motors reving hard. signed...migsy racing made better by Losi, Team Xtreme, HPI BAJA 5B. novak, castle creations, trak-power lipos bantam B6 and my SMR nicely done by huski sport uk. local club: Cwmaman RC Jammers. www.the-pred.co.uk RC BEARINGS 4 U. Club 22 (admin) Losi22, losi xxx cr losi xx-4, losi xxx-4G baja 5b 30.5cc. |
#4
|
|||
|
|||
Is this a 6v or a 7.2v fet servo.
|
#5
|
||||
|
||||
If it is the same setup you have been using for years then something has developed a fault. Could be anything from the battery to the ESC to the receiver to the servo. Try swapping a few parts over to see what makes a difference.
|
|
|