|
#1
|
||||
|
||||
2mm bolt thread sizes
Anyone know what tap i need for a 2mm allen headed Ansmann bolt, im thinking a M2 tap but not 100% sure
|
#2
|
|||
|
|||
It's metric so m2 sounds right to me.
|
#3
|
||||
|
||||
If it's for the normal buttonheads used throughout the car you'll need an M3 tap. M2 is too small.
|
#4
|
||||
|
||||
yup if it takes a 2.5 or 2mm allen driver the chances are its m3, measure the bolt diameter where the thread is is its 3mm get an m3 tap/die set
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#5
|
||||
|
||||
Cheers chaps, thanks for your help.
|
|
|