Lipo battery mod...possible?

[Panic]

Recently i purchased this saddle packs...http://www.amainhobbies.com/product_...ducts_id/32821 .
Their size is ok and they fit just fine in my Pred but the main problem is that the wires are too big/thick and they dont allow for the shell to close firmly. Everything is squeezed, wire touches the shaft etc etc. Is there any way to shorten them? or even i can change ie the plug from deans to corally bullet style so that i can save space?

Any suggestions will be welcome...thanks

[Lowie]

well, I'm no expert, but just my 2cts

the thick wire between the two packs is especially thick to permit the current to flow without resistance.
I guess you could open the packs and change the wiring ... but if I were you, I would sell that pack, buy a performant stickpack and make the Stickpack-mod on the Pred.

The car even drives better with it and IMHO it's easier to fit everything into the car.