|
#1
|
|||
|
|||
Problems with the b4 diff
Hey guys,
I have some problems with my diff and i hope u can help me I had rebuild the diff and replaced the diff rings and Bushings. The diff balls are only one race old - i changed the balls to ceramic diff balls. I had build the diff like shown in the manual, but if i turn one wheel it doesn't feel smooth - it's like feeling the diff balls. So has anyone an idea what i'm doing wrong? is it wrong to close the diff and then to open the diff an 1/8 turn? hope u can help me greets Sebastian |
#2
|
||||
|
||||
Did you replace the thrust race? Very important for a smooth diff.
|
#3
|
||||
|
||||
An obvious one i know but use plenty of diff lube.
|
#4
|
|||
|
|||
Hey guys,
Thanks for ur help.... @ sosidge: yes, i had replaced the thrust washers - the balls are the older one @ NeilD: i think i had use enough diff lube, but i will rebuild the diff again - i'm hoping it will work after it -.- |
#5
|
||||
|
||||
could you have overtightened the diff and crushed the thrust balls?iv done this myself a few times.have since started gradualy tightening the diff to the level i want rather than going to (what i thought was) fully tight and backing it of
|
#6
|
|||
|
|||
well, i had rebuild the diff and cleaned up everything and now it works smoothley.
I don't know what happend, because i had also cleaned it up by building the diff the first time... Thanks for ur help guys!!! Greets Sebastian |
#7
|
||||
|
||||
Glad you've got it sorted.
|
#8
|
||||
|
||||
By the way, you should always replace balls and washers at the same time. If either is worn then that will affect the diff's action.
|
|
|