|
||
|
 |
|
||||||||||||||||||
|
#1
18-06-2010
|
||||
|
||||
X6 saddle-pack chassis
X Factory releases today a new chassis for the X – 6 Squared that is CNC machined to accept saddle LiPo packs. Development work was done by U.K. National Champion Ellis Stafford, and The Big E used the first saddle chassis to win the last National at Eden Park Raceway. Stafford’s car was visibly faster.
 When the X - 6 was designed in 2005, LIPos were new and around 3000 mAh; these packs were quite light compared to cells. However, almost all drivers then used cells, and the X – 6 was primarily designed to use a 4 + 2 cell arrangement. With the mid motor design, this 4 + 2 arrangement concentrated the car’s weight in the center just ahead of the rear wheels. When the early LiPos were used, they were so light that a bit of extra weight to the side made little difference. Now we have 5000 and even 6000 mAh LiPos which are much heavier than the first packs. The new saddle pack chassis returns to the concentrated mass concept of the original. The car rolls less in corners and is more balanced in bumpy sections without use of a sway bar. X Factory’s molded plastic chassis is C.N.C. machined to Stafford’s design retaining maximum strength while the standard carbon fiber battery strap still fits properly. Today’s smaller E.S.C.s fit perfectly in front of the saddle packs. About 60 seconds with a rotary tool in one spot allows fitment of larger E.S.C.s #1009 chassies are shipping today to fine hobby stores all over the world, and are available now on X Factory’s web site, www.xfactoryrc.com Retail price $49.99 for the machined plastic chassis is still less than the original graphite.
__________________
If your PM doesn't at first succeed - try, try again. I'll reply in the end, honest.  
|
|
#2
18-06-2010
|
|||
|
|||
|
The first batch is currently sat in UK customs and should be cleared and available middle of next week......
UK RRP is £36.99 - press releases going out to all UK dealers in the next few hours........
__________________
 ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
|
#3
19-06-2010
|
||||
|
||||
|
Hi all
Great stuff seeing the X Factory lads working real hard to maintain their status as one of the best 2wd outfits. Oh! and congrats to Ellis for his EPR 2wd 2010 National win using this Saddle Pack Chassis. RudeBits have designed a new Saddle Pack Carbon Lipo Brace for the new chassis, so look out for it in a couple of days at www.rudebits.co.uk All the best for now .....
__________________
|
|
#4
21-06-2010
|
|||
|
|||
|
chassis
sorry just read post properly
|
|
#5
29-06-2010
|
||||
|
||||
|
Carbon Saddle Pack Brace
__________________
|
 |
|
|
Linear Mode
