|
#1
|
|||
|
|||
SV2 Pivot pins
Just a query really, and wondering if anyone else has had an issue with the pivot pins on the front arms that hold the pivots to the front arms. Never had a problem with them until about 2 weeks ago, and since then, they have come loose, or completely fallen out in about half of the races and heats I have partook in. The irritating thing is that Schumacher do not have any in at the moment, so I am not sure whether the pin has somehow fouled and needs replacing. The other room is fine, and has never been an issue.
Thoughts? |
#2
|
||||
|
||||
I had the opposite, mine seemed as if they weren't threaded properly.
|
#3
|
||||
|
||||
Hi,
I would say you have probably over tightened at some point and the plastic has become worn, I've done it myself... The kit plastic one's are made of a hard compound as appose to the medium flex one's which are made of a lot softer material, however both are fine unless over tightened. Your best bet is to get a fresh set of arms and start again. Hope this helps. Rob
__________________
Schumacher-Racing |
#4
|
|||
|
|||
Got some new front arms ordered, so hopefully this will cure the problem. Thanks for the advice.
|
#5
|
||||
|
||||
Small drop of super glue on the threads should do the trick..very small drop.
|
#6
|
||||
|
||||
I just put the pivot pin through the wishbone in the other direction and tighten it up...works for me.
Chris |
#7
|
|||
|
|||
Think it was the arm as I have changed it now and it all seems good now.
|
|
|