|
#1
|
||||
|
||||
Sx3 front diff coming undone
Tried the Diff in both ways round and it keeps coming undone. Any Ideas?
__________________
Trader Feedback Here. |
#2
|
||||
|
||||
Have you put the locking screw in the ther side??
__________________
TLR, Screwz4RC, Spektrum, Horizon Hobby, Trinity, Trishbits, Racer, RichPaint, RDT products, Sanwa, Zen Racing, Silverback Lipo's http://www.screwz4rc.co.uk My Trader Feedback - http://www.oople.com/forums/showthre...hlight=tyreman
|
#3
|
||||
|
||||
i'll check now
__________________
Trader Feedback Here. |
#4
|
||||
|
||||
__________________
Vega RB6 - Orion - Apex Models - JE Models - Cable ties
|
#5
|
||||
|
||||
Ive not seen an SX3 diff but it looks the same design as the Cougar on the exploded diagram. Make sure the locking grub screw is really tight against the thrust assembley bolt or it may come undone. Use two allen drivers.
The other problem that happens with these diffs is when you compress the circlip too much when installing the thrust assembley. If its right, then it should be very difficult or almost impossible to turn the circlip once its installed. They can slip out of position loosening the diff off if you have compressed the circlip out of shape. |
#6
|
||||
|
||||
locking screw in thight
__________________
Trader Feedback Here. |
#7
|
||||
|
||||
defo the circlip then in that case, tke it apart spread the cir clip open and put it back in make sure it in real tight
__________________
Mattys the driver,my names carl
|
#8
|
||||
|
||||
Mint thank you guys. After nipping up the locking screw it seems to have not come undone.
__________________
Trader Feedback Here. |
|
|