|
#1
|
||||
|
||||
DB01-R and LiPo's
I was just wanted to know what if any mod's where made to the battery tray to fit stick lipo's. I was thinking of smoothing out the raised cell flashes in the tray. Any veiws, mod's used would be good.
Jk
__________________
DB01-R/RRR TRF 503 Carbon TRF 201XM,Fast Attack Vehicle.RC 10 Classic. Top Force Evo,Optima Mid, Mardave Cobra. |
#2
|
||||
|
||||
I ran 23mm tall lipos with no modifications at all. I did subsequently switch to the TA05 carbon battery strap - partly because it's slightly thinner but mainly cos it looked cool!
|
#3
|
||||
|
||||
Yep, for tall lipo's the ta05 carbon strap and spacers under the clip mounts do the trick, no other changes needed, even for big lipo's!
__________________
Dave "Amish FJ" Gibson RB Products ~ Yokomo Nuclear RC ~ Xpert ~ Hacker |
#4
|
||||
|
||||
I got a bit ocd with mine, dremeled out some of the cell webbing, just to lower the lipo a bit, so it sat a little and I was able to screw in the battery strap retainer posts a turn or two.
__________________
Answer RC SWorkz 35-3 SWorkz 350T SWorkz S12-2 Instagram: crazylthirteen Blogger: http://the-croucher.blogspot.co.uk/ |
#5
|
||||
|
||||
Thanks chaps, ill do the spacer thing for now.
__________________
DB01-R/RRR TRF 503 Carbon TRF 201XM,Fast Attack Vehicle.RC 10 Classic. Top Force Evo,Optima Mid, Mardave Cobra. |
#6
|
||||
|
||||
__________________
TRF502 TRF511 TRF201XMW |
#7
|
|||
|
|||
just dremel the webbing on the chassis so the tray is flat, the webbing stuff isnt even flat so the battery wont sit true every time u put it in, it means the battery sits better in the chassis as well as lower
|
#8
|
||||
|
||||
I didn't dremel the webbing but put some thick foam tape in the recesses on the bottom to cushion and grip the Lipo. The carbon strap is nice too.
|
|
|