|
#1
|
|||
|
|||
Flow setup for 13.5 boosted
Hi,
I am after some advice on speedo set up for a 13.5t boosted touring car. I have a Flow works competition speedo with the std firmware on it and currently run....indoors on carpet. 13.5 Gforce (black) motor on 40 actual Timing I am having problems with getting rear traction with the car and wondered if its purely a mech set up problem or perhaps the speedo settings and punch settings are way too aggresive? I am wondering if I should turn down the boost angle? or boost itself? Any thoughts? settings are 0/3/0/6/8/10/0 |
#2
|
||||
|
||||
What is your FDR I run Gforce motors but in blinky also with 40deg timing, this looks high for boosted would say 25ish 6.5 -7 FDR and bring your boost/turbo in slowly, for rear traction when I have trouble I tend to only additive the rears reduce steering EPA as much as can get away with reduce rear droop and stand rear shocks up before looking at the front.
|
#3
|
|||
|
|||
85/21 what ever FDR that is 7.29 probably a bit much for indoors! so 25deg (No 5) boost and 2.5% (No 6) boostangle?
Is it worth me upgrading the firmware yet bearing in mind its only my second week at touring cars after 10 years away. |
#4
|
||||
|
||||
They are a good tourqy motor so with a high FDR and 40* it will accelerate quickly but reducing them for boosted should settle it down
|
#5
|
|||
|
|||
anyone else got any advice or settings?
|
|
|