|
#1
|
||||
|
||||
48dp spur for 1/12th
hi guys after deciding its going to be a hole lot cheaper to replace my spur gear rather then buying a new set of pinions i need to know which spur gears to get,its currently got a 64 pitch spur but want a 48dp for it as i have loads of 48dp pinions.
i have a hot bodies cyclone12 with a crc rear axle n diff so need a spur to fit that any recommendations much appreciated
__________________
|
#2
|
||||
|
||||
Will depend on what rollout you are looking for. have a look on www.gearchart.com and work out which size for the range of pinions and tyre size that you have.
|
#3
|
||||
|
||||
Standard 64dp spurs are around 96T, the equivalent diameter 48dp spur is 72T. You can use bigger spurs, the standard Associated spur used to be 48dp 75T, but there is a limit to how big you can go due to the tyre diameter.
You can get them from Demon.
__________________
Visit my showroom |
#4
|
||||
|
||||
cheers ordering a couple later today,looked at the chart need to get my head round it
__________________
|
#5
|
|||
|
|||
if your running in stock, get the smallest you can, think you can get 65ish, see your in barnsely, i used to get my 12th stuff from charles at nitroflight models!
|
#6
|
||||
|
||||
on cells i used to run a 72t Kimbrough spur which is really the biggest you can go without the gear digging into the track & i never found anything smaller that would work, sadly on LiPo / blinky the MPR is a lot higher so had to switch to 64DP
|
|
|