|
#1
|
||||
|
||||
Losi wheels
I need help. How put losi wheels to my Cyclone D4.
Losi wheels have'nt hex. Sorry for my bad english. |
#2
|
||||
|
||||
losi wheels on d4
Hi pal,i run a hpi cyber 10 which is nearly the same as the d4 and iv'e been told that if you remove rear hex on drive shaft losi wheels fit,i haven't tried it yet.As for the front you can buy a conversion from hpi so you can use the smaller hex on the front,hope this helps.....
|
#3
|
||||
|
||||
OK! But I now i have new problem.
I bought used car and i don't know how remove rear hex. I unscrew one hexscrew but hex doesn't come out. |
#4
|
||||
|
||||
Its probably just a little tight - or even rusted on if they haven't looked after it. You might need to lever it off slightly.
__________________
Yz4 - Yz2 DEX210 - Cobra 4210- DEX410 RC10 Team - Manta Ray - RC10T Mini Trophy - Blizzard - Wheely King Tz4 - GT24B BMRCC Emergency back-up race controller (but only if nobody better is available) |
|
|