|
#1
|
||||
|
||||
501X/DB01 Split Pins?
Does anyone know where to get hold of some split pins (roll pins?) to replace the standard solid bar on the DB01/501X?
After losing a wheel hex last weekend I'd like to fit the other pins instead, unfortunately the losi/AE split pins seem a little too small. Any ideas? |
#2
|
|||
|
|||
Get some thread retainer (not thread lock), it cures to a thick, sticky gunk that will hold the pins in place but still allow you to remove them if necessary.
__________________
Quote:
pm me bitch, or is it past your bedtime?
|
#3
|
|||
|
|||
Or.....nail polish
Does the same as above, but adds a touch of colour to your ride lol
__________________
Previously: BRCA Micro Section Chairman. BRCA Micro National Champion. Currently: JQ fan. Bellend. Forums are better than Facebook groups |
#4
|
|||
|
|||
Do you have to reapply that every time you remove a pin?
__________________
Quote:
pm me bitch, or is it past your bedtime?
|
#5
|
|||
|
|||
I probably would, but then I have an unhealthy interest in nail polish lol
__________________
Previously: BRCA Micro Section Chairman. BRCA Micro National Champion. Currently: JQ fan. Bellend. Forums are better than Facebook groups |
#6
|
|||
|
|||
Shoe goo would work on them pete, or maybe some hot bodies/hpi wheel pins(solid too). Think i ran them in my 501. Also search mx websites as stuff called Grip Glue works well made by Renthal for sticking handlebar grips on.
__________________
~ICON-RC~ATOMIC CARBON~LMR~TONISPORT~NUCLEAR RC~
|
#7
|
||||
|
||||
Thanks guys, I'll use shoe goo for now and keep looking
|
|
|