|
#1
|
|||
|
|||
xx4 Rear hub (Problem)
This is proberbly goin to make me sound thick, on my rear arms, im running standard xx4 graphite rear arms there are two holes for which the hinge pin will slot threw the hub carrier. which ones should be used?
If i try and use the outer hole the dive shaft does not reach the outdrives and if i use the inner one they only just sit inside. are my drive shafts wrong, or is it the rear arms? cheers Rob
__________________
|
#2
|
||||
|
||||
Inner hole mate
|
#3
|
||||
|
||||
And potentially cut the outer one off as they rub on certain wheels (AE maybe???)
The outer hole is from the BK2 geometry
__________________
Nortech is ACE! |
#4
|
||||
|
||||
Yea if you use AE wheels you have to remove some material off the end of the wishbone. Are you using CVD's or the std dogbones?
A
__________________
Ashley Williams I always thought by 2013 we would have flying cars, but we have got blankets with sleeves! |
#5
|
|||
|
|||
std bones mate
__________________
|
#6
|
||||
|
||||
Looks like you have BK2 arms, their inner hole is the same distance as the XX4 arms which has only a single hole.
If you are still having problems when you use the inner holes, make sure that you have the correct hub carriers. |
|
|