|
#1
|
|||
|
|||
CAT SX Build Tips
Thought I would just start this thread for information and tips when building the CAT SX.
Firstly I would recommend looking at the set up sheets in the back of the manual before building the car. Unfortunately the manual was designed well before a lot of the development work was done so does not necessarily reflect how the guys have run it. Secondly and quite importantly there are some features/settings on the car that can run you into trouble with the diff outputs both front and rear. It is possible if the car is run with a combination of some of the following it is possible to snap the diff outputs if they drop into the output slot under full bump; (as shown in the picture below) -Very narrow (Small amount of washers against transmission) -Very laydown shock -Short upper camber link -Very short shocks To check, hold the suspension at full bump with shock attached and make sure the driveshaft rotates smoothly and clears the slot. I for one will be running an O ring above the spring retainer for a bit of extra impact absorption. |
|
|