PDA

View Full Version : lipo care ?


Yoldume
07-11-2009, 05:35 PM
im on my 10th charge of my lipo pack and it still charges to 5000mah but only reads 8.14v as its final voltage

isnt it meant to be 8.4v is this normal ?

stampede vxlboy
07-11-2009, 05:39 PM
i dont think it matters some of my battery say 4.28 4.204.21 that on my 3 cells lipo

bodgit
07-11-2009, 05:44 PM
Have you checked them with a voltmeter?

Yoldume
07-11-2009, 05:45 PM
it only worries me because its slowly getting lower

hmmmmmm

i hate batteries

super__dan
07-11-2009, 06:15 PM
Lipos should charge to a final voltage of 8.40V (4.20V per cell if balanced correctly) providing you are using the right kind of charger on the right settings.

What are you using?

Could it be your charger has a 5000mah safety lockout and it's finishing then? That would explain why it's voltage is lower.

Marvin
07-11-2009, 06:31 PM
I would go with what Super-Dan said, most LiPO chargers have a 5000mAh cut-off, which must be changed.

Stick the pack on again, and see if it charges to 8.4V.

This may only occur after a few charges as LiPOs' capacity increases over the first few runs, so you'll actually get longer run-times after a few cycles.

Yoldume
07-11-2009, 08:08 PM
ahhh probs is the 5000mah cutoff so its never been fully charged

it always says that the voltage cutoff is 8.4v

cheers lads

Yoldume
07-11-2009, 08:57 PM
stuck it back on charge without the cut off it took another 815 mah and charged to 8.4v and balanced to 4.2v on both cells !!!

bin scratching my head for a few days and wondered why my car was a bit soft today at the park :drool: