|
|
#1
|
|||
|
|||
![]()
Hi. I bought the above speedo a while ago and just got around to install it. Soldered the wires on and fitted it to a motor. When i switch on the power goes to the receiver and the steering servo works, but the speedo doe snot go into setup mode and all that happens is that the 3 led's flash. No button pressing changes this.
Can anybody tell me what this means? It alos does this when i desolder the wires from the motor so i do not think it is a short or anything. Any clues? Thanks in advance. Tedje |
#2
|
|||
|
|||
![]()
Turn on and hold button on switch to enter programming mode - then follow instructions.
If the lights don't do as you expect - basically it may not acknowledge your input / button presses and hence not let you get to the end of the setup. If this happens - it's normally the reverse on the throttle on your TX that needs switching. Reverse it and try again. |
#3
|
|||
|
|||
![]()
I have tried with and without setup. Will try the tx reverse. The lack of a proper manual is a pain. Thanks.
Does anybody know where to find a manual. Apart from the hobbyking website? |
#4
|
|||
|
|||
![]()
Make sure the sensor wire is installed correctly.
Press down the set up button. Keep it pressed and turn it on. When the yellow light comes on release the sett up button. It worked for me Good luck |
#5
|
|||
|
|||
![]()
done all that pdr. Thanks
Its just as soon as i switch on that all three lights start flashing either pressing the setup button or not. |
#6
|
|||
|
|||
![]()
Change the sensor wire, im pretty certain its broken! .... i run these esc's and that's what they do if your sensor cable is faulty!
swap it out and it should work! :-) |
#7
|
||||
|
||||
![]()
Have a look at this not sure if it will help but worth posting https://www.youtube.com/watch?v=tbnGhWb65X8
|
#8
|
|||
|
|||
![]()
Thanks for the ideas guys. I will probably send it back.
Just a shame that there is no proper manual for this with proper fault diagnosis. |
#9
|
|||
|
|||
![]()
Tried it with a different motor and it came up straight away. No flashing. Just went straight into tellow light and motor turned. Turbo also worked.
Case closed. Thanks for the help. Tve. |
![]() |
|
|