Couple TM2 V2 questions

[fivepointnine]

1: what is the center CVD pin size and are they able to be pressed out? (mine are worn)

2: anyone know a source for the insert set for the rear? Inside line does not list them.

[vrooom]

the pin is 2.5mm yes you can press them out but its HARD.

[Top Dollar]

2: anyone know a source for the insert set for the rear? Inside line does not list them.[/QUOTE]

Kev will be able to get them for you, just ask him.

The part number you want is T04139

[Clive Loynes]

If that's what you are after then Kev does list them:

http://www.insidelinemodels.com/insi..._category_id=0

[fivepointnine]

Yeah I found the set under the TM4 section. Thanks guys!