|
#1
|
||||
|
||||
Are all wheels equal?
Got loads of Kyosho wheels and expected them to slot directly onto a Yokomo Bmax
Shock horror the fronts fit and the rears don't (the kyosho wheels need a slightly wider hole to fit the 12mm hexes) In short is it best to buy new wheels or just ream the middle and also, what are the most 'universal wheels' these days? Schumachers
__________________
Offroad: Asso B7 and 74.2 Onroad: X4F, Atom,TT01 Vintage: RC10 Worlds, B4, XXX-CR, Bosscat, ZX5 FS2, ZXRR Trader Feedback Link http://www.oople.com/forums/showthread.php?t=88156 |
#2
|
||||
|
||||
jconcepts monos for me
__________________
YZ2 sanwa hi-tec Balls out zx6 Futaba orion sanwa Need a liner resized ? Liars run for cover the truth is taking over!!! |
#3
|
|||
|
|||
Deffo not all equal. I got loads of schumacher rears. Wony fiy my b5m's properly. You cant fullly tighten down the wheel nuts as theres some axle poking thru wheel.
Solution was wheel nuts in lathe and bore back out slightly lol
__________________
AE all the way RC10B6.1d Maclan powered RC10T6.1 Maclan powered RC10B74 Maclan powered #rcoctane #teamrcoctane |
#4
|
||||
|
||||
So it's seems that there is not a easy solution
I think I will just ream the hole a mm or two. Seems a shame that could not move to a universal standard. I guess though the manufacturers make a little money in having alight difference in axles and hexes. Anyways thanks for the replies
__________________
Offroad: Asso B7 and 74.2 Onroad: X4F, Atom,TT01 Vintage: RC10 Worlds, B4, XXX-CR, Bosscat, ZX5 FS2, ZXRR Trader Feedback Link http://www.oople.com/forums/showthread.php?t=88156 |
#5
|
||||
|
||||
Quote:
What rear hubs do you have plastic or Alu Schu wheels do fit I use pre glued pretty much every week on Alu 7mm spacers Both me and my boy used pre glued on Sunday as well
__________________
|
#6
|
||||
|
||||
Kyosho and X-ray wheels have a different offset to AE and Yokomo
__________________
|
#7
|
|||
|
|||
I have schelle ally rear hubs
Its only about just sub 1mm of shaft that pokes thru. Could put washer on then nut and that sort it.
__________________
AE all the way RC10B6.1d Maclan powered RC10T6.1 Maclan powered RC10B74 Maclan powered #rcoctane #teamrcoctane |
#8
|
||||
|
||||
Not sure the width the shelle hubs are the kit 7mm Alu hubs allow the whe to be tightened with no washer
__________________
|
#9
|
||||
|
||||
if you look at different makes you can get all sorts of offsets of 12mm hexes, from as little as 4mm up to the 10mm+ hpi truck ones. some wheels do need the centre hole enlarging slightly to fit things like the associated and losi imperial axles, not a big deal and easy to do. personally if the wheel is too thin for the axle, it gets a washer tucked inside
|
|
|