|
#1
|
|||
|
|||
Problems setting throttle on esc with new receiver
Hi, I am trying to set up my esc on my dex210 rtr.
The esc and motor is a speed passion revention combo. I have managed to bind the RTR receiver ok and set up the throttle settings using the bundled radio gear. All ok. The problem comes when I put in a core rc fhss receiver (because I want to run all cars from my one transmitter). The receiver is bound and steering response is great, however when I am trying to set the throttle points on the esc I am getting no response. I have tried reversing the setting on the transmitter, switched off all the EPA and trims but I am getting no response at all. Battery is fine and esc seems to work with the other setup. Any ideas???????? |
#2
|
||||
|
||||
Try disconnecting a motor connection? Worked for me.
__________________
DEX210 RTR DEX210 KIT SUPASTOX SPEEDPASSION REVENTON PRO SP GT2.0 PRO AUDI S3 OEM Sat in the garage/semi-retirement. TOYOTA AVENSIS -WORKHORSE CHEVROLET SPARK - KIDS TAXI
|
#3
|
|||
|
|||
??? bit confused, how would that work? I know you have to disconnect a motor wire to bind the receiver....but to set the throttle you have to put back all the motor plugs even on the rtr setup.
Just can't fathom if it's a receiver issue or not |
#4
|
||||
|
||||
I had a similar problem. Not sure how or why but found by disconnecting a motor connection then reconnecting the ESC binded without any problems.
__________________
DEX210 RTR DEX210 KIT SUPASTOX SPEEDPASSION REVENTON PRO SP GT2.0 PRO AUDI S3 OEM Sat in the garage/semi-retirement. TOYOTA AVENSIS -WORKHORSE CHEVROLET SPARK - KIDS TAXI
|
#5
|
|||
|
|||
Well blow me, your solution worked! Gave it a shot this morning and all works fine!
|
|
|