|
#1
|
|||
|
|||
LRP Flow for 2wd offroad carpet
Hi folks,
Which firmware do you guys use for 2wd offroad on carpet? Still v3.8? Also, what is a good base setup for such a scenario? |
#2
|
|||
|
|||
I use the 3.8 version with blinky settings. Br2 brakes with no drag brake and dial down on the transmitter. I find any other brake setting and its either too aggressive low rpm and no high rpm or vice a versa.
|
#3
|
||||
|
||||
I run v3.8 on 3-2-2-2-0-0-1. Take torque boost to 2 if you need a little more punch
|
#4
|
|||
|
|||
Many thanks for the reply guys.
Much appreciated! |
#5
|
|||
|
|||
One question...all these settings are always done with brake EPA set to 80% as recommended by the manual right?
|
#6
|
||||
|
||||
I've always set my epas to 100% before setting up my esc. Then adjust from there to suit requirements.
|
#7
|
||||
|
||||
As Dan rightly says, set everything to 100% then dial down, not before.
|
#8
|
||||
|
||||
I use standard esc and dont mess with the settings, just change motors according to what speed I want.
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS |
#9
|
||||
|
||||
I still prefer the V3.3 Offroad Firmware on my LRP Flow, as its noticeably Smoother than the Newer V3.8!
|
#10
|
||||
|
||||
Just wondering as im going to use a flow on yz-2, i asume it will come with 5.4fw so are the other firmwares older or just versions of the same release to suit different classes of rc ?
What I mean is should I go on 3.8 if I'm using a 2wd buggy or stick with newer firmware.
__________________
Last edited by Noob; 28-07-2016 at 11:28 PM. |
#11
|
||||
|
||||
Quote:
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS |
#12
|
||||
|
||||
Thanks for the advice
__________________
|
#13
|
|||
|
|||
I have a speedo with 3.8 installed, usb bridge and a 7.5 x20 if you are interested, the 3.8 software is much better for off road I think.
|
|
|