New additions to TRF UK!

[Alex H]

Having larger DIFFballs means larger area that have contact with the rings and less pressure is necessary. Much like wider tyres on a car.

[94eg!]

Originally Posted by Alex H

Having larger DIFFballs means larger area that have contact with the rings and less pressure is necessary. Much like wider tyres on a car.

But Tamiya balls have always been 3mm. Perhaps your comparing them to other brands of vehicles?

Originally Posted by pugs

The avante, vanquish and avante 2001 used geared diffs, not ball diffs, the egress used 3mm diff balls

Your forgetting the center ball diff that was standard on the Avante, Avante 2001 & Vanquish...

[pugs]

Your forgetting the center ball diff that was standard on the Avante, Avante 2001 & Vanquish... [/QUOTE]

no, I didn't, the thread is about a review of diff balls, not centre diff balls , they were 3mm though

[94eg!]

Originally Posted by pugs

no, I didn't, the thread is about a review of diff balls, not centre diff balls , they were 3mm though

Well if you want to go that route.........Your so-called Egress ball diffs are actually an Avante hop-up released at the same time as the Avante back in 1988. Therefore the Avante did have front & rear ball diffs (w/ 3mm balls)...

[pugs]

Only if you bought them

[Fredrik Emilsson]

Come on!
This thread is about the new TRF site, not Tamiya model history.

[GRIFF55]

Good call Fred!!! Where can i get your covers for the 511 please?(as seen on trfracing.co.uk)

[Fredrik Emilsson]

Just send me a PM