|
#1
|
||||
|
||||
![]()
Would a lipo 46 x 68.5 x 31mm each case fit a B44?
|
#2
|
||||
|
||||
![]()
i mesured my lipo holder it is 69 x 46.5 and the space between the chassis and top deck is 37mm so they would go , you would probably need to get a longer grub screw for the thumb screw , the only other prob maybe the bodyshell , i use an azarashi one so it is quiet low over the batts but i cannot say about others
|
#3
|
||||
|
||||
![]()
im thinking of getting the higher cap inntellect batteries myself but worried it might touch the driveshaft?69x46.5x25mm
|
#4
|
||||
|
||||
![]()
Ive just done a quick mock up and they do fit with the standard shell.
|
#5
|
||||
|
||||
![]() Quote:
jobs a good un ! one last thought is will the be enough room for the 4mm plug (corally) to go in ? as the ones towards the centre tuck under the deck dont they? unless they are the ones with wires and deans . |
#6
|
||||
|
||||
![]()
As long as you solder the wire on a right angle to the corrally it will fit, im only doing this cos i am tight and these size cells are half the price of the regular size ones.
![]() |
![]() |
|
|