|
#1
|
|||
|
|||
Longer rear cvd?
Hello guyz. I wonder is there any longer rear cvd set or dogbone that can fit on the bj4we? Thinking of putting xx4 shocks all around without the dogbones coming off during a jump. Know what i mean? Thanks
|
#2
|
||||
|
||||
Hi there, i think i know what you mean. You are on about getting a longer dogbone so it will go further into the diff out-drive. But the next bigger size up i beleive is a b4 dogbone. But when i tried these on the bj4we i had a hard time trying to get them on, and then when i got them on they were so far into the outdrive that the suspension wouldn't work. But i am not sure about any other ones that may fit. By the way when i say i had a hard time getting them on, i had to take the hub carrier of as they wouldn't fir otherwise.
Hope this helps you out a bit.
__________________
B4 5.5 L4 19T RC18t Mamba 9200Kv
|
#3
|
||||
|
||||
On our X - 6s we use B4 hardware (hubs, dogbones) with BK2 axles for the same reasons : have more droop without popping out the dogbone.
They push the dogbone inward something like 3-4mm. See here : http://www.2wdrc.com/tech_bk2_axles.html Dunno if it would fit, but the hubs are the same as on your car. |
#4
|
|||
|
|||
Ok guyz. Thanks for the fast reply . I will try out the x-6 set up as i have both the bk2 and b4. But first i have to find these 2 cars....hmm where did i put them lol
|
#5
|
||||
|
||||
With your nickname, I may have an idea...
|
#6
|
|||
|
|||
|
|
|