|
||
|
 |
|
||||||||||||||||||
|
#1
15-08-2011
|
||||
|
||||
B3 Team avec new shell and wheels
So ive gone against the purists and have put all sorts of new stuff on my retro ride most notably some rather bright rpm ball ends and ive dyed my wheels black and gone a bit out of period with the paint!!
brushless setup works well so far despite keeping original b3 clutch and diff.... have managed to break a few arms but no worries as this puppy is a pure basher all the original parts still in the original box etc so whenever i sell it will be put back to stock!
__________________
RC10 B3 Team / Losi XX4 WE (in progress!) Nosram Matrix Evo / Nosram Matrix Reverse LRP Vector X11 10.5t / Nosram Storm 4.5t KO Propo 2343 / KO Propo 2173 Sanwa RX 311 Sanwa Super Exzes Trakpower & Bionic Bantam BC6 
|
|
#3
17-08-2011
|
||||
|
||||
|
Nice, looks good. Where did you get the shell from, as I am a bit fed up with the B2 and B3 shell and need a change.
Im using a B4 slipper system and layshaft as its a direct fit and handles 6.5 and 5.5 with ease and have redesigned the rear shock tower in graphite and now have attached a Schumacher rear wing system as it doesnt come off and the wing lasts longer. Ive also cut the lugs off the inner side of the wishbones at the front so when it is attached to the chassis hub you can put the alloy plate (like a B2) and the also attached another alloy plate as per the B3 manual and this gives strength to the front a bit more. Oh and added Losi 1042 axles and some more UJ spacers as this give more droop. Hope this info helps.
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS
|
|
#6
24-10-2011
|
||||
|
||||
|
details in my signature!
__________________
RC10 B3 Team / Losi XX4 WE (in progress!) Nosram Matrix Evo / Nosram Matrix Reverse LRP Vector X11 10.5t / Nosram Storm 4.5t KO Propo 2343 / KO Propo 2173 Sanwa RX 311 Sanwa Super Exzes Trakpower & Bionic Bantam BC6
|
|
#8
27-11-2011
|
||||
|
||||
|
Anyone interested in a race prepared for lipo b2 with a very rare alloy front centre bulkhead, alloy rear brace (plus another new one), longer ujs so plenty of droop, rude tony brass plates, carbon fibre front and rear towers, and batt holder designed for use woth lipos plus loads of new (mostly) and used spares including six sets of wishbones, three sets of drive cups (very rare) drive gears, enough to build a few more. Car is immaculate with my pro painted design shell.
Oh yeah two new in packet bodyshells uncut and several sets of new wheel sets as well as a few used.
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS
|
 |
|
|
Linear Mode
