|
#1
|
||||
|
||||
Sanwa M12 Binding Problems :(
Hi guys/gals
I have probably the same problem everyone else has on here. The story begins like this, I purchased and received on Friday my spanking new Sanwa M12 and RX-462 I was ecstatic. I had them paired on the Friday night and was tinkering happily. I turned it off and went to bed. in the morning i tried to re bind after a couple of alterations but all the receiver does is flash for 10 seconds slowly and doesn't seem to be receiving a signal from the transmitter. I have cleared the models saved just encase and reverted anything back to standard I can think of, with no luck. I do believe there is no way of resetting either component. If this isn't true please say I'm in need of serious help mentally and physically If anyone has any suggestions please say I'm desperate?!?! Thanks all Sam
__________________
Tyres and suspension alterations baffle me please help??? |
#2
|
||||
|
||||
Did you ever sort this out? Having same problem
|
#3
|
||||
|
||||
Really interesting as I have a similar prob as well
|
#4
|
||||
|
||||
presume it is nothing obvious like the different setting modes for compatibility?
See the link below http://www.lrp.cc/fileadmin/Download...ode_MT4_en.pdf
__________________
I've got Araldite and a Swiss Army Knife - what more do I need? Yokomo YZ-2 No 4WD because nothing lives up to my original Optima. Until now maybe?... |
#5
|
||||
|
||||
Nope as I switched to an already binded one and that didn't work
|
|
|