|
#1
|
||||
|
||||
K1 not fitting in BRCA Box
hi ive just fitted the 10 degree alloy pivot blocks on my k1 with 2m of track washers front and back, ive just tried to put it in a box 250mm wide and the nuts seem to be catching on the side of the box it will go in with excessive force but then i cant pull it out im just wondering if i have done anything wrong.
thanks in advance heres a pic http://i1313.photobucket.com/albums/...ps0edf846c.jpg
__________________
Wots up doc |
#2
|
||||
|
||||
kit is only 1mm front track washers and as far as im aware thats what the team run.
simple answer if its too wide take some washers out!
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#3
|
||||
|
||||
hmm i wonder how mossy is fitting his in the box as im going off his setup and apparently hes ran 2m track
__________________
Wots up doc |
#4
|
||||
|
||||
Simon's setup uses 1mm track width spacers at the front.
__________________
Trader Feedback |
#5
|
||||
|
||||
__________________
Wots up doc |
#6
|
||||
|
||||
1) The setup sheet you're copying wasn't a BRCA event
2) His latest setups use 1mm
__________________
Trader Feedback |
#7
|
||||
|
||||
ahh ok
thanks
__________________
Wots up doc |
#8
|
||||
|
||||
I have 2mm washers on the front of mine with alloy blocks and it fits fine. Ran it at last regional.
|
#9
|
||||
|
||||
2mm on the front of a K1 will be very wide. It was fairly wide on the SX series, and the K1 bulkheads are wider.
__________________
Matthew White |
|
|