|
#1721
|
||||
|
||||
Quote:
Remember kev lee is pro, he can likely drive the car super aggressive |
#1722
|
|||
|
|||
Danny
I ended up setting the throttle expo to -50 on the transmitter and the used throttle profile 1 and dual mode at 20 degrees on the speedo. My neutral width was set a 52. I think I need to reduce the neutral width to have a more responsive throttle. I also loosened the slipper, It was easier to drive and I kept improving round by round, wish I had done it earlier. What do you set the speedo and expo to when running out doors at Batley? |
#1723
|
||||
|
||||
my neutral width is set to 5 on my RS and RS Pro. i think Dannys is 7 or 10 from memory. 52 will just remove lots of bottom end throttle control and create a bigger deadband around the stick centre where nothing happens.
i keep my throttle linear, but a little expo does help smooth the response a bit on a wheel radio.
__________________
-------------------------------------------------------------------------------------------------------------------
Team Yokomo - YZ-2CAL3 | YZ-2DTM3 | YZ-4SF2 | YZ-2T | YZ-2DTM Worlds | YZ-2DTM x2 | YRX-12 x2 ------------------------------------------------------------------------------------------------------------------- 10electric | Batley Buggy Club | YORCC | RHR | MB Models --------------------------------------------------------------------------------------------------------------- |
#1724
|
||||
|
||||
Quote:
I think with a trigger the expo gives a better feel. I find a lot of stick users don't like it so much. |
#1725
|
||||
|
||||
setup advise
Hi,
Could someone please suggest a good starting set up for a Tekin RS Pro in a Lazer ZX5 FS2 with a 5.5t motor, running in door at Chadderton then out door on high grip astro (would you run the same settings) Any advice appreciated Matt
__________________
Kyosho zx-5 fs2 Kyosho Rb6 Tekin RS Pro B44.3 Renault Clio 1.5 Speed machine Sanwa |
#1726
|
||||
|
||||
Quote:
http://www.teamtekin.com/hotwire/esc...stone_v223.pdf
__________________
Tekin Team Manager |
#1727
|
|||
|
|||
Looks like the softwares been updated.
No description on the play store (yet), can anyone confirm what is in the new release. |
#1728
|
||||
|
||||
Quote:
10.2 Includes the following features: 250 firmware platform specific to the RSX, RS GEN2, RS SPEC and RX8 GEN2. Pending ROAR Approval Added BEC Voltage to Data Logging New display features in Data Logging for run comparisons
__________________
-------------------------------------------------------------------------------------------------------------------
Team Yokomo - YZ-2CAL3 | YZ-2DTM3 | YZ-4SF2 | YZ-2T | YZ-2DTM Worlds | YZ-2DTM x2 | YRX-12 x2 ------------------------------------------------------------------------------------------------------------------- 10electric | Batley Buggy Club | YORCC | RHR | MB Models --------------------------------------------------------------------------------------------------------------- |
#1729
|
|||
|
|||
Fwiw that's the old software description.
The description on the play store has been updated now. Bit more detail regarding software versions and gen 1 support. I'll be ordering a hotwire today. |
#1730
|
|||
|
|||
trouble with phone app
Hi, I downloaded the app and ordered an adaptor lead for my phone.
All connected up and the phone does not see the hotwire, my lead and hotwire works fine on a mates phone but not mine. My phone is running android jelly bean so should be ok ? My phone does connect via a data cable to PC so its not the phone, hotwire or adaptor so what's going on ? Any help appreciated. |
#1731
|
||||
|
||||
Quote:
If the adaptor is not the issue, try uninstall the hotwire app and download sgain. Its possible you have an older version. |
#1732
|
|||
|
|||
Any ideas whose got this in stock in the UK (or EU) as tekins dealer page is next to useless, unless i want to become an importer, which would be nice, but not exactly financially sensible!
|
#1733
|
||||
|
||||
Quote:
I got my rsx from mb models. Previously i had got my tekin gear from insideline racing as they had a price cheaper than most shops could buy them for at the time. Mb likely have stock. |
#1734
|
|||
|
|||
Yeah, hotwire 2.0, sorry should have been clearer!
MB and inside line either don't list the 2.0, or don't have stock. |
#1735
|
|||
|
|||
RC Disco stock these items, if they are not on the web site give greg a call,
RC Disco import Tekin into the UK 01530 414417. |
#1736
|
||||
|
||||
Quote:
So when you plug in the HW to your phone, does the green led light up?
__________________
Tekin Team Manager |
#1737
|
|||
|
|||
Quote:
Thanks in advance. |
#1738
|
||||
|
||||
On some of the Razr phones you must plug in and power up the car. The phone doesn't supply enough power via the USB OTG cable. Powered USB hubs also work.
__________________
Tekin Team Manager |
#1739
|
|||
|
|||
hotwire app
Hi Randy, tried plugging in the hotwire and powering up the car. Still not working but do get a rapid flashing green light on the hotwire. App still does not see the hotwire being connected at all on my phone.
|
#1740
|
|||
|
|||
hotwire app
Hi Randy, tried plugging in the hotwire and powering up the car. Still not working but do get a rapid flashing green light on the hotwire. App still does not see the hotwire being connected at all on my phone.
|
|
|