|
#1
|
||||
|
||||
B6 build - gearbox - high point?
Just screwed the gearbox to the chassis and realised that the gearbox has a really stiff/high point at about every complete revolution of the out-drives. Anyone know where I should start looking, I will be taking it apart but if anyone has any insights let me know and I will start there - thanks!
Last edited by brizzlemark; 10-07-2016 at 08:28 PM. Reason: Inability to spell! |
#2
|
||||
|
||||
Found it - two of the eight screws that hold the gearbox to the chassis were too long, went through the gearbox case and smacked into the gear diff. A chat with CML tomorrow I think.
Quote:
|
#3
|
||||
|
||||
That's a build error not a manual error or design error
Not sure what Cml will do about that
__________________
|
#4
|
||||
|
||||
Last 8 screws in the bag of the right type, no other screws of that type used in diff - last 8 things in the step in the manual. Unless I was meant to open another bag?
|
#5
|
||||
|
||||
Not sure then mine were all present and correct
__________________
|
#6
|
||||
|
||||
Seems odd , mine went together fine
__________________
|
#7
|
||||
|
||||
Some screws in some kits were the wrong length. I had this exact issue and reported it to cml who were very helpful. They already knew of the problem. Some of my chassis side rail screws were wrong too.
|
#8
|
||||
|
||||
Good to hear I wasn't the only one, annoying really as I religiously checked every other one, just these last ones all looked the same and were last from the bag. Will make sure I check the rest and see what CML do. Apart from that quite impressed with the quality of the kit.
|
#9
|
||||
|
||||
CML have sorted this for me - good work CML.
Quote:
|
|
|