|
||
|
 |
|
||||||||||||||||||
|
#1
26-08-2016
|
||||
|
||||
Cleaning metal parts at home
Guys,
How do you clean up your vintage drive shafts? I have a number of shafts that have surface rust or are losing their colour, is it just a case of a wire brush on a dremel and then spray black. What sort of spray is best for this? Also what is the best way to clean ali parts like steering knuckles? I only have basic equipment at home.. thanks Jamie 
|
|
#2
28-08-2016
|
|||
|
|||
|
Hi Jamie,
Personally, i used a product to blacken the steel which made miracle. I cannot make the difference between a new part ! You can find this stuff in a hunting store or the hunting section at WallMart . This product is used on the FireArm to restore them and it's not expensive . You can make a research on BLUING Steel ! When you blacken(Bluing) steel it is like a dyeing! I did all the parts such as Drives Shaft , Tie Rod , U'J , Diff Outdrive and also Screws . Here is my Tip  ROY
|
|
#3
28-08-2016
|
||||
|
||||
|
I used gt85 to start with and a white top sponge from asda as it doesnt scratch as much as the green pad
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS
|
 |
|
|
Linear Mode
