|
#1
|
||||
|
||||
1258 in b44?
Hi. Thinking about getting a savox 1258 servo for my b44 but someobe said they thought the casing would need to be filed down to fit?
Does anyone have any advice on this? Would a 1251 low profile be better? Thanks |
#2
|
||||
|
||||
I used to run one in my B44. Fits straight in.
__________________
Team Schumacher www.racing-cars.com Paint by www.customblitz.co.uk Feedback http://www.oople.com/forums/showthread.php?t=67178 |
#3
|
||||
|
||||
Tvm
Cheers for that.
|
#4
|
||||
|
||||
I have the standard Savox servo and everything fits fine.
|
#5
|
||||
|
||||
Thanks guys - 1258 on the way!
|
#6
|
|||
|
|||
In the b44.1 it will need the edge dremelled down yes!
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
#7
|
|||
|
|||
strange, it didnt in mine?
__________________
~ICON-RC~ATOMIC CARBON~LMR~TONISPORT~NUCLEAR RC~
|
#8
|
||||
|
||||
Not sure...was going to say I didn't do anything to mine either...but then I have a vague memory that I maybe just trimmed a tiny bit of the corner off the top corner of the mounting flange to give a touch more clearance next to the drive shaft?
Got one in mine quite happily though...only very minor 'tweak' if anything is needed
__________________
AKA: Andy Nancollis 1/10th drives: Yokomo BMax2MR & BMax4 1/16th drive: Carisma GTB Racing in South West: http://www.mendiprcraceway.co.uk/ Racing in Wales: www.caldicotrcracers.co.uk Kept running by: Yokomo via MB Models & www.tracksidespares.co.uk Shells by Square Crabs |
|
|