|
||
|
 |
|
||||||||||||||||||
|
#1
30-12-2012
|
||||
|
||||
8mm Chassis Lipo no Fit :-(
Played out with my new 210 and put a +8mm chassis on it straight away.
When I put the battery holders in my LRP lipo won't fit. Am I only supposed to use one holder?
__________________
Aidan Burke - Southport Radio Car Club #SchumacherFamily #TQmodels #ExtraLapRCpodcast 
|
|
#3
01-01-2013
|
|||
|
|||
|
How to do it correctly is on the Durango website.
|
|
#4
02-01-2013
|
||||
|
||||
|
|
|
#6
23-02-2013
|
||||
|
||||
|
Or if your not moving the batteries around just emery the blocks down, I found taking 0.5mm off each block made enough room for my saddles, took about 10mins and for 0.5 surely can't upset things to much, unless the part of the idea behind the foam is to allow the chassis to flex as the battery isn't fixed between the 2 points.
__________________
----Cougar 2 team----Cougar 2 works----Cougar 2000---- ----Schumacher Bosscat---- ----Traxxas TRX1----Losi XXX CR----Losi XXX BK2---- ----AE B4 ft----Xfactory X6^----DEX210 V1---- ----TLR22 3.0----TLR22 4.0----TLR22t 4.0----TLR22 5.0AC---- ----AE B6.4----
|
|
#7
23-02-2013
|
||||
|
||||
|
I drilled two new holes slightly further back at the rear.
#sorted
__________________
Andy Grason - Sponsored by G. Singh Racing. Team Whiplash DEX210 Tresrey | DEX410 v3 | My Paint Work | My Trader Feedback
|
 |
|
|
Team Durango
Linear Mode
