|
#1
|
|||
|
|||
Servo horn for Savox servo B44.2
Just at the electrics/servo install part of my B44.2 and so far everything has run smoothly
but when i get to the bit for installing the servo,I cannot get a kit supplied servo horn to fit. Normally for a savox servo i use a 25t or Futaba horn, but the kit supplied futaba horn is either too small or too tight of a fit to actually go on my servo. has anybody else had this issue? any advice would be appreciated thanks |
#2
|
|||
|
|||
There might be some flashing from the moldings etc.
If it is 25T then I would try using some force. |
#3
|
|||
|
|||
Quote:
U not the only 1 |
#4
|
||||
|
||||
the 25T fits perfectly, but is tight. Don't be afraid of using the screw to push the horn on.
|
#5
|
|||
|
|||
cheers for the info guys i'll give it some elbow grease and see where i end up :-)
|
#6
|
|||
|
|||
Quote:
Put the first bit on then screw it on ensuring the threads are lined up You will also need to trim some plastic off the casing so the arm doesn't hit it potentially Fit and try and then remove and mod
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
#7
|
||||
|
||||
i agree very tight I almost gave up and went to buy an alternative
but it does go with a bit force
__________________
Dynamix Raceway Benfield rc club Moss Models Associated B44.2 Associated B5M Schumacher SV2 Savox - sp pro - gens ace Sanwa exzes Z |
|
|