|
#1
|
|||
|
|||
Durango Hex Modifications
Tired of loosing those pins on your DEX210 or DEX410?
Hopefully the admin can make this a sticky or add it in the tips and tricks section. Just made a few mods to the existing wheel hex. Thought I might share it with you guys. You just need part #704046 Test to make sure the screw sits flush in the hex or the wheel can't fit on. You need to shorten the pin slightly so that the screws can clamp onto the hex and not protrude out. If you can't put the wheel on, either the pin is too long or the holes for the counter sink is not deep enough. Trim any flashing so that the pin can slide in easily. |
#2
|
||||
|
||||
It's a good idea but not really required. All you need to do is put a small amount of the red thread lock on the pin and it won't come out or just fit alloy ones!
|
#3
|
|||
|
|||
i hav the alu ones and used some of the thread lock on them and it stuck them in there like super glue lol i couldnt get them out for a wile, i just try to b super careful with them now lol
|
|
|