KO universe stick tensions

[jimfreeman77]

Does anyone know how to adjust these? i have been told to undo the four screws which house the sticks and then undo/tighten a screw which adjusts the tension? but i cannot see any screws? help much appreciated

[Dazzler]

Hi,

You'll need to take the back off. Firstly carefully remove the rubber pads, and the battery holder. Then remove about six screws. Once the back is off you'll see the back of the two stick assemblies. You should see one screw in each which is long and protrudes rather than screwed down tight. Wind it in to add tension and out to reduce.

Not too hard, but go careful removing the rubers, they will come.

[jimfreeman77]

Originally Posted by Dazzler

Hi,

You'll need to take the back off. Firstly carefully remove the rubber pads, and the battery holder. Then remove about six screws. Once the back is off you'll see the back of the two stick assemblies. You should see one screw in each which is long and protrudes rather than screwed down tight. Wind it in to add tension and out to reduce.

Not too hard, but go careful removing the rubers, they will come.

cheers i didnt know you could remove the rubber pieces