|
||
|
 |
|
||||||||||||||||||
|
#1
23-01-2011
|
|||
|
|||
Masking chequers/checkers/diamonds
I fancy some of the above on my new shell(it'll be airbrushed BTW).
Just wondering what the preferred method of masking them is? Do folks use liquid mask and a very steady hand on the knife(rules me out then  )?Is carefully cut masking tape the way to go? Are there pre-cut masks out there? I was thinking of using 2" masking tape,drawing the chequers on,cutting them out and then putting them on the inside of the body/wing where I want them. A bit tedious I know... Mark 
|
|
#2
23-01-2011
|
||||
|
||||
|
All of the above
 Liquid mask precut masks(if you cant find any give me a shout and I can make one for you) tape - either cut by hand as you would in liquid mask or lay a grid down with the tape then just cut the center squares out.
|
 |
|
|
Linear Mode
