alloy motor plate brace

[paulc]

hi all
if anybodys got a e speed alloy motor plate brace for the x-6 they want to sell pm me

cheers paul

[bigred5765]

lesro is probably the only place ull get one from

[footey]

paul get on msn

[Chrislong]

Lesro currently doesn't have stock, I know that Footey wants one too.

Daryl said he'll be getting them in with his next order from USA, not sure when though.

But don't fret, as the plastic one is adequate until the alloy ones are back in the UK again.

What to do... of the two screws going through it from under the chassis, replace the one on the outside of the motor plate with a longer screw and put a lock nut on it, one of those gold mini-nuts from Losi is ideal for the job. Then the other screw which threads into the plastic, just tighten it to pinch tight.

With the new 4 gear, you can put a screw from behind the plate through the brace and a nut on it (another gold one), this is strong. With the 3 gear, where it taps into the plate, use thread lock.

Chris

[Northy]

Or you could use them nice blue Nor-Tech nuts Chris....

G

[rcracer]

Originally Posted by paulc

hi all
if anybodys got a e speed alloy motor plate brace for the x-6 they want to sell pm me

cheers paul

you can look at my shiney blue e speed alloy motor plate brace Paul but you cant buy it ....

[Chrislong]

Originally Posted by Northy

Or you could use them nice blue Nor-Tech nuts Chris....

G

Your doing more and more parts all the time! Good news (I want some... lots infact!) Id also recommend to all reading his solid wheel drive pins, im personally sick of snapping the brittle roll pins.

[super__dan]

This is how I mount mine. Note cos the motor plate screw slot is slotted for the tranny height it's important to screw/bolt the T piece to the chassis and then do the motor plate up with an allen driver (L shaped one)

[Col]

Is this the same as the one on the XXX4? I have one of those if anybody is interested...

[super__dan]

It's the blue T piece in the pic above he's after, what's like that on the xxx4?

[Northy]

Originally Posted by super__dan

This is how I mount mine. Note cos the motor plate screw slot is slotted for the tranny height it's important to screw/bolt the T piece to the chassis and then do the motor plate up with an allen driver (L shaped one)

And that's one of those faggot motors

[Northy]

Originally Posted by Chrislong

Your doing more and more parts all the time! Good news (I want some... lots infact!) Id also recommend to all reading his solid wheel drive pins, im personally sick of snapping the brittle roll pins.

Hopefully the pins should be here this week Chris, if I can be arsed with Worksop I'll bring you some. You forgot my nuts too Haha.

G

[Chrislong]

I want your nuts!

[bigred5765]

and they obviously work
ask his Julie
i want some to g

[Col]

Originally Posted by super__dan

It's the blue T piece in the pic above he's after, what's like that on the xxx4?

Nothing!! Sorry, image was blocked on work laptop...