|
||
|
 |
|
||||||||||||||||||
|
#1
03-10-2011
|
||||
|
||||
my xx4 crawls
finally got the beast fired up but alas only a fraction of the drive gets transferred to wheels
the pinion spins and meshes nicely against the spur but this does not translate into drive do i need to go through the motion of adjusting the diffs and then slipper or is there something more basic im missing i have a lesro one way so presumably the manual instructions for adjusting the front diff dont apply?
__________________
RC10 B3 Team / Losi XX4 WE (in progress!) Nosram Matrix Evo / Nosram Matrix Reverse LRP Vector X11 10.5t / Nosram Storm 4.5t KO Propo 2343 / KO Propo 2173 Sanwa RX 311 Sanwa Super Exzes Trakpower & Bionic Bantam BC6 
|
|
#2
03-10-2011
|
||||
|
||||
|
sounds like your slipper is very loose or not quiet built right maybe ? Then check the diffs maybe the front one could be in the wrong way ? just some sugestions . holding the white pulley on the slipper shaft you should just be able to move the spur with quiet some force as a rough guide until you get it in the car and set up properly.
|
 |
|
|
Team Losi Racing
Linear Mode
