|
|||||||||||||||
|
#1
|
||||
|
||||
|
hi ive just fitted the 10 degree alloy pivot blocks on my k1 with 2m of track washers front and back, ive just tried to put it in a box 250mm wide and the nuts seem to be catching on the side of the box it will go in with excessive force but then i cant pull it out im just wondering if i have done anything wrong.
thanks in advance heres a pic http://i1313.photobucket.com/albums/...ps0edf846c.jpg
__________________
Wots up doc |
|
#2
|
||||
|
||||
|
kit is only 1mm front track washers and as far as im aware thats what the team run.
simple answer if its too wide take some washers out!
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
|
#3
|
||||
|
||||
|
hmm i wonder how mossy is fitting his in the box as im going off his setup and apparently hes ran 2m track
__________________
Wots up doc |
|
#4
|
||||
|
||||
|
Simon's setup uses 1mm track width spacers at the front.
__________________
Trader Feedback |
|
#5
|
||||
|
||||
|
__________________
Wots up doc |
|
#6
|
||||
|
||||
|
1) The setup sheet you're copying wasn't a BRCA event
2) His latest setups use 1mm
__________________
Trader Feedback |
|
#7
|
||||
|
||||
|
ahh ok
thanks
__________________
Wots up doc |
|
#8
|
||||
|
||||
|
I have 2mm washers on the front of mine with alloy blocks and it fits fine. Ran it at last regional.
|
|
#9
|
||||
|
||||
|
2mm on the front of a K1 will be very wide. It was fairly wide on the SX series, and the K1 bulkheads are wider.
__________________
Matthew White |
![]() |
|
|